Child pages
  • Peering Interface Configuration

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

To ensure that your connection to the INX is easy, as well as secure, we have created a set of templates for the configuration of various types of hardware in common use at the exchange point.

Although we do filter specific types of Layer-2 frames, we still encourage peers to keep their ports clean, and may insist on this before moving you out of quarantine.

Connection via a router

 We recommend that you use a Layer 3 device to connect to the INXes;  doing so, minimises your risk of creating any unnecessary loops.  Below are some configurations that should help if you connect directly to a router (preferred)


Classic IOS

Code Block
titleCisco IOS
interface <INT>
ip address 196.223.x.x 255.255.255.0
ipv6 address 2001:43f8:1fx::y/64
description PEERING:: *INX
no ip redirects
no ip proxy-arp
no cdp enable
no ip directed-broadcast
no mop enable
no keepalive 
no udld mode aggressive
ipv6 nd ra suppress


IOS-XR

Code Block
titleCisco XR
interface <INT>
 description PEERING:: *INX
 mtu 9216
 ipv4 address 196.223.x.x 255.255.255.0
 ipv4 verify unicast source reachable-via any
 ipv4 unreachables disable
 ipv6 nd suppress-ra
 ipv6 nd dad attempts 0
 ipv6 verify unicast source reachable-via any
 ipv6 address 2001:43f8:1fx::y/64
 ipv6 unreachables disable
 load-interval 30


Juniper

Code Block
titleJuniper
interfaces {
    ge-0/0/0 {
        description "PEERING:: *INX”;
        unit 0 {
             family inet {
                 no-redirects;
                 address 196.223.x.x/24;
             }
            family inet6 {
                 address 2001:43f8:1fx::y/64
            }
        }
} 


Mikrotik

Code Block
titleMikrotik
/interface ethernet set ether1 comment="PEERING:: *INX"
/ip neighbor discovery set ether1 discover=no
/ip address add interface=ether1 address=196.223.x.y/24
/ipv6 address add interface=ether1 address=2001:43f8:1fx::y/64 advertise=no
/tool romon port disable numbers=<Interfacenumber of Ethernet>


Connecting via a switch

Cisco

Code Block
vtp mode transparent
!
no spanning-tree vlan 9999
!
vlan 9999
 name INX
!
interface <INT>
 description PEERING:: *INX
 switchport mode access
 switchport nonegotiate
 switchport access vlan 9999
 spanning-tree bpdufilter enable
 no keepalive
 no cdp enable
 no lldp receive
 no lldp transmit
 no udld enable
end


Table of Contents